PLOSIVES: classification in consonants

 PLOSIVES: classification in consonants

A plosive is a consonant articulation with the following characteristics: • One articulator is moved against another, or two articulators are moved against each other, so as to form a stricture that allows no air to escape from the vocal tract. The stricture is, then, total. • After this stricture has been formed and air has been compressed behind it, it is released - that is, air is allowed to escape. • If the air behind the stricture is still under pressure when the plosive is released, it is probable that the escape of air will produce noise loud enough to be heard. This noise is called plosion. There may be voicing during part or all of the plosive articulation. To give a complete description of a plosive consonant we must describe what happens at each of the following four phases in its production:
 • The first phase is when the articulator or articulators move to form the stricture for the plosive. We call this the closing phase.
• The second phase is when the compressed air is stopped from escaping. We call this the compression phase.
• The third phase is when the articulators used to form the stricture are moved so as to allow air to escape. This is the release phase.
• The fourth phase is what happens immediately after (iii), so we will call it the post-release phase.

 English plosives 

English has six plosive consonants: p, t, k, b, d, g. The glottal plosive ? occurs frequently but it is of less importance, since it is usually just an alternative pronunciation of p, t, k in certain contexts. The plosives have different places of articulation. The plosives p, b are bilabial since the lips are pressed together; t, d are alveolar since the tongue blade is pressed against the alveolar ridge . Normally the tongue does not touch the front teeth as it does in the dental plosives found in many languages. The plosives k, g are velar; the back of the tongue is pressed against the area where the hard palate ends and the soft palate begins . The plosives p, t, k are always voiceless; b, d, g are sometimes fully voiced, sometimes partly voiced andsometimes voiceless.  All six plosives can occur at the beginning of a word (initial position), between other sounds (medial position) and at the end of a word (final position). To begin with we will look at plosives preceding vowels (which can be abbreviated as CV, where C stands for a consonant and V stands for a vowel), between vowels (VCV) and following vowels (VC).
i) Initial position (CV): The closing phase for p, t, k and b, d, g takes place silently. During the compression
phase there is no voicing in p, t, k; in b, d, g there is normally very little voicing - it begins only just
before the release. If the speaker pronounces an initial b, d, g very slowly and carefully there may be
voicing during the entire compression phase (the plosive is then fully voiced), while in rapid speech there may be no voicing at all.
The release of p, t, k is followed by audible plosion - that is, a burst of noise. There is then, in the
post-release phase, a period during which air escapes through the vocal folds, making a sound like h.
This is called aspiration. Then the vocal folds come together and voicing begins. The release of b, d, g is followed by weak plosion, and this happens at about the same time as, or shortly after, the beginning of voicing. The most noticeable and important difference, then, between initial p, t, k and b, d, g is the aspiration of the voiceless plosives p, t, k.
The different phases of the plosive all happen very rapidly, but the ear distinguishes clearly between p, t, k and b, d, g. If English speakers hear a fully voiced initial plosive, they will hear it as one of b, d, g but will notice that it does not sound quite natural.
If they hear a voiceless unaspi- rated plosive they will also hear that as one of b, d, g, because it is aspiration, not voicing which distinguishes initial p, t, k from b, d, g. Only when they hear a voiceless aspirated plosive will they hear it as one of p, t, k; experiments have shown that we perceive aspiration when there is a delay between the sound of plosion and the beginning (or onset) of voicing.

In initial position, b, d, g cannot be preceded by any consonant, but p, t, k may be preceded by s. When one of p, t, k is preceded by s it is unaspirated. From what was said above it should be clear that the unaspirated p, t, k of the initial combinations sp, st, sk have the sound quality that makes English speakers perceive a plosive as one of b, d, g; if a recording of a word beginning with one of sp, st, sk is heard with the s removed, an initial b, d or g is perceived by English speakers.

 • Medial position (VCV): The pronunciation of p, t, k and b, d, g in medial position depends to some extent on whether the syllables preceding and following the plosive are stressed. In general we can say that a medial plosive may have the characteristics either of final or of initial plosives.

• Final position (VC): Final b, d, g normally have little voicing; if there is voicing, it is at the beginning of the compression phase; p, t, k are always voiceless. The plosion following the release of p, t, k and b, d, g is very weak and often not audible. The difference between p, t, k and b, d, g is primarily the fact that vowels preceding p, t, k are much shorter. The shortening effect of p, t, k is most noticeable when the vowel is one of the long vowels or diphthongs. This effect is sometimes known as pre-fortis clipping